How To Pair the Sauna Light Remote
Follow these steps to pair the remote control to the light:
- Switch off the power and unplug the sauna from the outlet.
- Switch on the power and plug the sauna into the outlet.
- Switch off the power and unplug the sauna from the outlet.
- Switch on the power and plug the sauna into the outlet.
- Point the remote at the gray electrical box (where the LED receiver is) and immediately short-press any one of the four number keys on the remote control three times.
- The LED lightstrip in the sauna should blink 3 times to confirm it has paired.
Note: If you lag on any of the first 4 steps it wont work. It has to be fairly quick with a good rhythm.
After following these instructions, if the light still isn’t connected, go into your Uku Controller and make sure the “lamp” setting is turned on.
There is another setting that says “light”, do not change that setting.
/!\ WARNING: Do not place your remote inside the sauna. The high heat of the sauna will melt electronics.
Comments
0 comments
Please sign in to leave a comment.