Setting Up the Freeze to Death Cold Plunge Tub

  • Updated

Read First Before Setting Up Your Plunge

Please read the Safety Precautions and Warranty before setting up the Freeze to Death Cold Plunge.

Set Up

Step 1: Placing the Freeze to Death Cold Plunge

  • Place the Freeze to Death Cold Plunge on a waterproof, flat, and stable surface. The surface must be flat within 2 degrees and outdoors only.
  • Please note: If you have the Standard Chiller, refer to the Chiller manual for location requirements.
Step 01_transparent.png

Step 2: Install the Safety Strap

  • Please Make sure the safety strap is placed underneath the tub before filling. 
strap_transparent.png

warning sign" Emoji - Download for free ... If you purchased the Evolve Standard Chiller please go here. warning sign" Emoji - Download for free ...

Step 2: Secure Manifold Plugs

There is a manifold plug on the jet port and the drain port. Make sure to tighten the collars until they are hand-tight to prevent leaking.

Step 2 (1).png

Step 3: Fill the Freeze to Death Cold Plunge

  • Make sure the white drain valve is in the closed position (perpendicular to the tub).
  • Fill the Plunge with water until it reaches 4 inches from the top.
Freeze to Death Cold Plunge_1-1_no filter_transparent.png

Step 4: Add Ice and Plunge!

 

Step 4 (1).png

Was this article helpful?

0 out of 0 found this helpful

Have more questions? Submit a request

Comments

0 comments

Please sign in to leave a comment.