Setting up your Plunge (Cold-Only)

  • Updated

The following explains how to set up the plunge standard and XL models that do not heat. 

Step-by-Step

STEP 1: Location Requirements

• Place the Plunge on a flat surface that
can support 1,200 lbs
• Keep it 5 feet from any appliances.
• Place the chiller behind the tub with 12’’
between the chiller and the wall for
proper air flow.
• Let the chiller rest for 4 hours before
turning on to allow coolant to settle.
Note: Failing to do so may result in
chiller malfunction.

 

 

 

Step 1.png

STEP 2: Attach the "in" connection

Screw on the "In" connection from the water pump to the "In" connector on the chiller.

 

Step 2.png

STEP 3: Fill the Plunge

• Attach the included carbon hose filter
to a hose.
• Run water through it into a drain until
the water turns clear.
• Fill the Plunge with water.

Recommended water level:

Indoor = 4.5" from the top

Outdoor = 3" from the top

 

Step 3.png

STEP 4: Attach the "out" connection

Screw on the "Out" connection from the water filter on the "Out" connector on the chiller.

DO NOT connect the "Out" connection until the Plunge is half full.

 

Step 4.png

STEP 5: Plug in the Plunge

Plug the main cord from the electrical box into a GFCI outlet (110-120v).

  • Standard = 15 Amp breaker
  • Pro/XL = 20 Amp breaker
  • Check for water flowing out of jets.

DO NOT move onto the next step if no water is flowing from the jets.

Note: If you plan to use an extension cord, it needs to be 12 gauge to give the Plunge sufficient power up to 25ft. Please follow all NEC requirements.

 

Step 5.png

STEP 6: Plug in the chiller

Plug the chiller into the empty outlet in the electrical box.

 

Step 6.png

STEP 7: Set Temperature

• Start by holding the “Set” button until you hear
a beep and see numbers flashing.
• Press the up or down arrows until you reach
your desired temp.
• Press “Set” to lock it in. Note: The cooler will
automatically keep the water within 3 degrees
of your set temp.
Note: The cooler will automatically keep the
water within 3 degrees of your set temp.

 

Step 7.png

STEP 8: Operate Light

Turn the light on/off via the silver button on
the left side of the tub.

 

Step 8.png

Step 9: Attach Phone Mount

Install the phone/tablet mount by attaching the
two suction cups to the Plunge and rotating each
one clockwise until fully secure.

Step 9.png

 

 

Was this article helpful?

9 out of 20 found this helpful

Have more questions? Submit a request

Comments

0 comments

Article is closed for comments.