The following explains how to set up the plunge standard and XL models with a heating component.
Step-by-Step
STEP 1: Location Requirements• Place the Plunge on a flat surface that |
|
STEP 2: Attach the "in" ConnectionScrew on the "In" connection from the water pump to the "In" connector on the chiller. |
|
STEP 3: Fill the Plunge• Attach the included carbon hose filter Recommended water level: Indoor = 4.5" from the top Outdoor = 3" from the top |
|
STEP 4: Attach "Out" ConnectionScrew on the "Out" connection from the water filter on the "Out" connector on the chiller. DO NOT connect the "Out" connection until the Plunge is half full. |
|
STEP 5: Plug in the Plunge• Plug the main power cord from the electrical DO NOT move onto the next step if no water is Note: Do not use an extension cord — plug the Plunge directly into the dedicated outlet. Use of an extension cord is not supported. Damage caused by using an extension cord is not covered by the limited warranty. Please follow all NEC requirements. |
|
STEP 6: Plug in the Chiller
Plug the chiller into the outlet labeled 'COOLING' in the electrical box. |
|
STEP 7: Set TemperatureYou’ll control the temp with the Inkbird WiFi |
|
STEP 8: Operate LightTurn the light on/off via the silver button on |
|
STEP 9: Attach Phone Mount
Install the phone/tablet mount by attaching the two suction cups to the Plunge and rotating each one clockwise until fully secure. |
Comments
0 comments
Article is closed for comments.