Manual and Setup Guide for the Plunge: Gen 2 Tub

Updated February 24, 2025 17:37

Read First Before Setting Up Your Plunge

Please read the Safety Precautions and Warranty before setting up the Plunge: Gen 2.

Set Up

Step 1: Placing the Plunge

Place the Plunge on a waterproof, flat, and stable surface.
Please note: If you have the Evolve Pro Chiller, refer to the Chiller manual for location requirements.

Frame 1.jpg

If you purchased the Evolve Pro Chiller please go here.

If you purchased the Evolve Standard Chiller please go here.

Step 2: Secure Manifold Plugs

There is a manifold plug on the jet port and the drain port. Make sure to tighten the collars until they are hand-tight to prevent leaking.

Step 02 (2).png

Step 3: Fill the Plunge

Make sure the white drain valve is in the closed position (perpendicular to the tub).
Fill the Plunge with water until it reaches 4 inches from the top.

Frame 2.jpg

Step 4: Add Ice and Plunge!

Step 04.png

Was this article helpful?

0 out of 0 found this helpful

Have more questions? Submit a request

Comments

0 comments

Please sign in to leave a comment.