How to Drain and Refill the Plunge All-In Commercial Max

Tubs Compatible With These Instructions:

• Plunge All-In Commercial + Auto Doser
• Plunge All-In Commercial Max

Drain and Refill

1. Pause the Plunge and wait for the jets to turn off. 
2. Turn off the Plunge by unplugging the power cord or pressing the “test” button. Do not drain the tub while the tub is paused, it must be off. This can cause potential damage and void your warranty.
3. Close the two colored ball valves (perpendicular to the piping). Important note: Do not open the colored ball valves during the draining process to protect the Auto Doser Probe from air exposure and drying out. 
4. Remove the ventilation screen on the side opposite of the filter housing. 
5. Remove the cap from the drain spigot
6. Attach a garden hose to the drain spigot 
7. Turn the white ball valve on the drain spigot on (parallel to the piping) and the water should flow out. Note: gravity and length of the hose will effect how quickly the water drains out. 
8. Replace the cap after draining
9. Take this time while the Plunge is empty to clean the drain strainers by following these instructions
10. Refill the Plunge and follow the initial setup instructions

Frequency Requirements:

Please note: If you do not follow the frequency requirements for your tub setup your warranty could be voided. 

• Plunge All-In Commercial + Auto Doser - Every 2 weeks at minimum
• Plunge All-In Commercial Max - Every 2 weeks at minimum