Changing the Filter (Evolve Pro Chiller)

Tubs Compatible With These Instructions: 

• Plunge Evolve XL Pro
• Plunge Evolve XL Pro Commercial
• Plunge Air Pro
• Plunge Pop-Up Pro

Changing the filter 

1. Pause or turn off your Evolve Pro Chiller, then double-check that there are no jets running. 
2. Close the colored ball valve by turning it perpendicular to the connection. 
3. Remove the circular filter housing cover by lightly pressing it to lift it. 
4. If the filter housing lid is too tight, you can use the provided filter wrench to twist it open to reveal the filter. Please make sure the colored ball valve is close and the chiller is off before opening the filter housing. 
5. Take the dirty filter out and place the clean filter in. Please make sure that it is fully set in the filter housing before screwing the lid back on.
6. Check to make sure the o-ring is still seated at the top of the filter housing and there is no debris in the crevice. 
7. Screw the filter housing lid back on and make sure to hand tighten only. Be careful not to over tighten because it can strip the threading. If there is resistance when screwing the lid on, make sure to check that your filter is set before continuing. 

Frequency Requirements:

Please note: If you do not follow the frequency requirements for your tub set up your warranty could be voided. 

• Evolve Series Tubs with a Evolve Pro Chiller - Every Month At Minimum
• Plunge Evolve XL Pro Commercial - Every Week At Minimum