Read First Before Setting Up Your Plunge

Please read the Safety Precautions and Warranty before setting up the Party Plunge.

Location Requirements:

Place the Party Plunge outside only.
Place the Party Plunge on a level and waterproof surface that can hold over 4000 lbs. (400 gallons of water + Tub + Plungers)
Consider placing the Party Plunge on a surface that conducts less heat to prolong the ice. (i.e. Asphalt gets hotter than grass)

Set Up

Step 1: Placing the Protective Ground Cover Find the gray protective ground cover and unwrap it. Clear the area where you intend to place the Plunge of debris. Place the ground cover outside on a level and waterproof surface of your choice.* Keep in mind ice will melt faster if placed on a surface that conducts more heat. I.e. Asphalt *Note: If you purchased the Evolve Pro Chiller, please follow the location requirements in the chiller manual.
Step 2: Placing the Party Plunge Unwrap the Party Plunge and place it on top of the gray protective mat.
Step 3: Inflate the Party Plunge Connect the black air pump and inflate the tub until it reaches 8 PSi.
Step 4: Inflate the Cover Connect the black air pump and inflate the cover to 8 PSi.

Find the manifold plugs pictured and place them on the drain and jet manifold, sealing them closed. There should be 4 total.
Make sure to tighten the collars and the drain valve until they are hand-tight to prevent leaking.

Make sure both of the white drain valves are in the closed position (perpendicular to the tub).
Fill the Party Plunge with water until it reaches 4 inches from the top.
The tub holds approximately 400 gallons of water.