Step 1: Placing the Protective Ground Cover

• Find the gray protective ground cover and unwrap it. Cover Dimensions: 63”x37”
• Clear the area where you intend to place the Plunge of debris. 
• Place the ground cover on a waterproof location of your choice.*

*Note: If you purchased the Evolve Pro Chiller, please follow the location requirements in the chiller manual.

Step 2: Placing the Plunge Air

Unwrap the Plunge Air and place it on top of the gray protective mat. 

Step 3: Inflate the Plunge Air

Connect the black air pump and inflate the tub until it reaches 8 PSi.

Step 4: Inflate the Cover

Connect the black air pump and inflate the cover to 8 PSi.

Step 5: Secure Manifold Plugs

• Find the manifold plugs pictured and place them on the drain and jet manifold, sealing them closed.
• Make sure to tighten the collars and the drain valve until they are hand-tight to prevent leaking.

Step 6: Fill the Plunge Air With Water

• Make sure the white drain valve is in the closed position (perpendicular to the tub).
• Fill the Plunge Air with water until it reaches 8 inches from the top.

Step 6: Add Ice and Plunge!