Changing the Filter (Evolve Standard Chiller)

Tubs Compatible With These Instructions: 

• Plunge Evolve XL Standard
• Plunge Air Standard 
• Plunge Pop-Up Standard

Changing the filter 

1. Turn off your Standard Chiller, then double-check that there are no jets running. 
2. Close all three colored ball valves by turning them perpendicular to the chiller connections. (Only close the ball valves when the chiller is fully off)
3. Using the filter wrench, slide it onto the clear filter housing and unscrew it. Please note that some water may come out. 
4. Remove the dirty filter and put a clean filter in. Please go here if you need filters. 
5. Replace the filter housing, making sure not to cross thread it when you screw it back on. Please hand tighten only. 
6. Open all three colored ball valves back up by turning them parallel to the tub. 
7. Unlock the chiller UI and press the power button to turn the chiller back on. 

Frequency Requirements: 

Please note: If you do not follow the frequency requirements for your tub set up your warranty could be voided. 

• Evolve Series Tubs with a Evolve Standard Chiller - Every Month At Minimum